UPPER UNIT // 01
TOPS + OUTERWEAR
Prioritize chest, shoulder, sleeve and garment length. Size up when you want room for layering.
SHOP LAYERSNONE UNIT // FIT SYSTEM
SIZE + FIT
Measure once. Check the product chart. Choose the unit built for your intended silhouette.
FIT PROTOCOL // 01
- 01Measure your body
- 02Open the product chart
- 03Choose the closest unit
PRODUCT DATA OVERRIDES GENERIC SIZING.
Every silhouette is cut differently. Use the SIZE + FIT panel on the product page before ordering.
SYSTEM 01
MEASURE THE BODY
Use a soft tape. Keep it level and close to the body without pulling tight.
- 01Chest / Bust
- Measure around the fullest point, keeping the tape straight across your back.
- 02Waist
- Measure where the garment will sit. For low-rise bottoms, measure below the natural waist.
- 03Hip
- Stand with feet together and measure around the widest point of the seat.
- 04Inseam
- Measure from the crotch seam to the desired hem. Include stacking allowance when needed.
- 05Foot length
- Stand on paper, mark heel and longest toe, then measure the straight-line distance.
QUICK CONVERT
CM / INEnter either value. The other unit updates automatically.
SYSTEM 02
CHECK BY PRODUCT
Use these measurements as inputs. The final size decision comes from each product's own chart.
LOWER UNIT // 02
BOTTOMS
Prioritize waist, hip, rise and inseam. Compare the listed garment waist with where you wear it.
SHOP BOTTOMSGROUND UNIT // 03
FOOTWEAR
Use standing foot length, then allow for sock thickness. If between sizes, follow the product note.
SHOP FOOTWEARSYSTEM 03
FIND THE PRODUCT CHART
- 01Open the product page
- 02Find SIZE + FIT beside the size selector
- 03Switch between CM and IN inside the chart